Uwatec X-Tek Especificaciones descargar pdf (Pagina 7)

VALVE SET UP

SCUBAPRO X-TEK BC´s are completed by the BPI System(Balance Power Inator). It is possible

to change the SCUBAPRO Balance Power Inator to the X-TEK Inator. This must be done by an

authorized dealer or the company SCUBAPRO. The power inator, when connected to the tank

and regulator by a low pressure hose, makes it possible to control buoyancy in the water (ination/

deation of the BC) by using inate and deate buttons.

Connecting the Power Inator

The Power Ination Valve allows you to inate your BC using air from your SCUBA cylinder. Its LP

hose, threaded on a LP port of the rst stage regulator, is connected to the Power Ination Valve

by the Quick Disconnect Coupling.

To attach the Quick Disconnect Coupling:

1. Make sure that both ttings are free of contamination prior to connecting them together.

2. Pull back the collar of the Quick Disconnect Coupling while pushing the hose rmly onto

the tting plug found on the power ination valve.

3. Release the collar when the coupling is fully seated on the plug. Pull gently but rmly on the

hose to check for a secure connection.

4. To disconnect, pull the Quick Disconnect Coupling collar back and disengage the LP hose

from the plug.

WARNING

Keep water out of the inatable aircell of the BC. Repeated use of the oral valve or the

Overpressure Valve may allow water inside the BC, reducing the amount of buoyancy

provided by the BC. This could result in injury or death. Drain all water out of the BC prior

to every use.

OPERATION

Inating the BC with the Power Ination Valve

To inate the BC, press the Power Ination Valve Button. Air should enter the BC. For better

control during ination use short bursts of air by repeatedly pressing and releasing the power

inator button.

Inating the BC with the Oral Valve

The Oral Valve is found on the end of the airway. It allows you to inate your BC with your exhaled

breath. Use of this valve for ination is recommended on the surface or on land prior to diving. It

may be used when you cannot, or do not wish to add air to the BC with the Power Ination Valve.

1. First exhale a small amount of air into the mouthpiece of the valve to purge any water that

may be trapped there.

2. With the same breath, continue to exhale while deeply depressing the Oral Ination Valve

Button.

3. Release the Oral Valve Button when you inhale fresh air.

4. Repeat steps 2 and 3 until the desired amount of buoyancy is reached.

Deating the BC

Your X-TEK system may be tted with either a Manual Dump Valve or an Elbow without a

manual dump valve. Please follow the instructions for your particular BC conguration.

1 2 3 4 5 6 7 8 9 10 11 12 ... 44 45

Sin comentarios

Uwatec X-Tek Especificaciones Pagina 7