Uwatec X-Tek Especificaciones descargar pdf (Pagina 41)

Procedure:

1. Set the tanks parallel, the valves showing in one direction.

2. Screw the connector manifold into a valve. The space between A and B, (see picture

above) should be exactly the same as the measure between the clamps. (See sample

drawing page 37).

3. Fit the clamps on the Double Tanks and x it, as described on pages 38-39.

4. Rotate the connector careful into the valves. Take a tape measure and gauge the distance

between the valves to obtain the exact distance.

Space to be measured

A B

IMPORTANT!

Make sure that the space between the valves is exactly the same as those of the bands;

otherwise the valve manifold can be damaged.

1 2 ... 36 37 38 39 40 41 42 43 44 45

Sin comentarios

Uwatec X-Tek Especificaciones Pagina 41